Under-Sink RO OEM: Check Installation Fit Before Approving a Sample

An under-sink RO purifier may fit on a drawing and still be difficult to install in the cabinet. A drain trap, waste bin or door hinge can block the tubing route or leave too little room to remove a cartridge. Brand owners can catch these problems by testing the approved configuration in a representative cabinet before signing off on the sample.
Measure the space the installer can actually use
Record the cabinet opening and the usable space around the drain trap, shutoff valve and any pull-out bins. Check that the unit can pass through the opening and sit in the intended position with the doors closed. Ask the supplier for a dimensioned drawing showing the connections and the clearance needed to service the unit.

Mock up the connection routes
With the sample in position, trace the feed, drain and drinking-water lines. Follow the installation instructions for the exact model. Check that tubes can reach their connection points without being pinched by the cabinet contents, and that the shutoff valve remains accessible. If the configuration uses an external tank or power adapter, include it in the mock-up.

Try a filter change in place
Have the installer complete a cartridge change with the unit in position. Note any obstruction that requires moving the purifier or disconnecting tubing. Keep photos of the installed unit, connection routes and cartridge removal clearance with the signed sample record. If a housing or connection changes during production, use those records to decide what needs to be checked again.

For a Qiteng OEM inquiry, send the target cabinet dimensions, a photo of the plumbing layout and your preferred RO configuration. These details help define what to verify on the sample before bulk production.

Quick Inquiry